RESYNCLIMIT=HALF, BRCALMODE=PEAK, DEMODRAWDATASEL2=DIS
No Description
| BRCALEN | Baudrate calibration enable |
| BRCALMODE | Baudrate calibration mode 0 (PEAK): Measure period between peaks in demodulated signal. This mode can give false peaks for high oversampling ratios without sufficient datafiltering. 1 (ZERO): Measure period between zero-crossings in demodulated signal. This mode can miss zero-crossings for high frequency offsets. 2 (PEAKZERO): Combine peak-period and zero-crossing periods. This mode gives best accuracy, but includes weaknesses from both PEAK and ZERO modes. |
| BRCALAVG | Baudrate calibration averaging |
| DETDEL | Detection delay |
| TDEDGE | Timing detection edge mode |
| TREDGE | Timing resynchronization edge mode |
| DSSSCTD | DSSS Correlation Threshold Disable |
| BBSS | Baseband Signal Selection |
| POEPER | Phase Offset Estimation Period |
| DEMODRAWDATASEL2 | Demod raw data select 2 0 (DIS): Disabled. 1 (COH): Coherent demod 5-bit I and Q input data, 10-bit I and Q data after FOE/POE. 2 (CORR): 4-bit max_corr_index and 17-bit max_corr . 3 (CHPW): 8-bit channel power and 4-bit BBSSMUX 4 (BBPF): 11-bit pre-filter correlation output for BLR and 11-bit pre-filter correlation output for COH demod 5 (FSM): 5-bit Narrow-band BLE FSM state, 5-bit Long-range BLE FSM state, 3-bit DSA FSM state, 7-bit Detection FSM State. Captured each time state changes |
| FOEPREAVG | Frequency Offset Estimate Pre-Averaging |
| LINCORR | Linear Correlation |
| RESYNCBAUDTRANS | Resynchronization Baud Transitions |
| RESYNCLIMIT | Resynchronization Limit 0 (HALF): Adjust timing if accumulated timing is higher/lower than RESYNCPER/2. 1 (ALWAYS): Adjust timing if accumulated timing is non-zero. |